How to Install Chrysler 68RFE ZPak™ RZP-008 Overdrive Clutch Pack

view all articles
March 5, 2019

Chrysler 68RFE ZPak RZP-008

Contents:

1 UD/OD Pressure Plate

1 Thin Steel Reaction Plate

7 ID Splined Single Sided Friction Plates

7 OD Splined Single Sided Friction Plates

1 OD/Rev Pressure Plate

Installation Instructions

  • After installing the UD Clutch assembly with the snap ring, install the UD/OD pressure plate with the step facing up and then install the snap ring.
  • Install thin steel plate.
  • Starting with an inside splined single sided friction plate, install friction side facing down.
  • Install an outside splined single sided friction plate, friction side facing down.
  • Continue alternating id and od splined plates until all 14 single sided friction plates are installed.
  • Install the large waved snap ring (OE Snap ring) Install the stepped pressure plate step side down.
  • Install the large flat snap ring (OE Snap ring) Install the reverse clutches as normal.

Check OD clutch clearance with a dial indicator and 20 psi of air pressure. Any other method may produce different results.

Clearance should be .030 - .063

For Technical Assistance on the installation of this product, please call 800-729-7763.



posted by: Nathan Truncone   comments: 0

Where To Buy

  • Search By State
  • Search By Country